How to use our Kits
How to Use the Buttheadz Grow Kit
- Buttheadz guide chart
- Setting Up your Grow Space
- Vegetative stage
- Flowering Stage
- Harvesting
- Starting a Plant
Simple Guide for BUTTHEADZ Grow Kit:
Unboxing the Kit and Setting up for Grow Space
1. Take out 1 grow bag fill ¾ the way full and set on one of the provided saucers (Big Bag fill and leave a couple inches before top of bag.
2. Premoisten the BUTTHEADZ Grow soil filled bags by adding 4 cups of water.
3. Then plant your newly seeded plants or clones by pulling soil away from center adding in the plant and covering the roots.
Grow the plant in a Vegetative state
1. Keep humidity between 55% and 75% and temperature between 70F and 90F.
2. Light can be 24in from plant set between 40% to 70% and light timer needs to be 18 hr on 6hr off.
3. When watering in veg use a quart container to water. To see if you need to water stick your finger into the soil about 1 inch and see if it is damp. If it is, don't water. If it is dry, add water. Add water a cup at a time. You can also pay attention to the humidity if humidity is lower than normal you may need to add a little water. The water needed will be less at start and increase as the weeks go by.
4. Feed the soil by way of the Buttheadz growth chart provided with your kit or found online ___link here__
Growing plants in the Flower Stage
1. Flowering temperature is ideally at 75-85 °F.
2. Light can be now set between 70% to 100%
3. Change timer to 12hr on 12hr off.
4. The ideal cannabis flowering humidity is between 40% to 60%. During flower, lowering your relative humidity level can help prevent mold and mildew from forming.
5. Watering During flower will increase. Ideally water with 32oz of water checking daily if the soil is dry.
6. Feeding the soil by way of the Buttheadz growth chart provided with your kit or found online ___link here__
Knowing when to Harvest.
1. Harvesting your Flower, you need to have trichomes all cloudy with 20% to 30% amber.
2. Hang to dry for 4 to 7 days when stem starts to snap its dry
3. Keep humidity between 45% and 55%
4. Keep temp between 55F and 70F.
5. After drying place in cure bag keeping humidity between 60% and 65%
6. Burp or open jar or bag once a day for the first week then once a week after that for first month
Starting your seedling or clone
1. Keep light 24 inches from the plant and keep light at a low setting between 30 and 40 percent.
2. Keep Humidity Between 60%-75% and temperature Between 65-75 degrees Fahrenheit
3. Then plant your seeds 1/2 inch to one inch deep in soil and lightly cover.
4. Then place a clear dome over the seedling lifting the dome off the plant once a day to release excess humidity.
5. Keep the Humidity dome on the plant until the leaves fully develop which can take a 2 or 3 weeks.